Tilley X 246 B Lamp fully working and with all accessories shown
Meths jar, Funnel, 3 Mantles, ignitor torch and lighting instructions.
Tilley Lamps burn for approx 12 Hours on one Tank of Standard Paraffin (1-1/2pints)
(They do need to be pumped up as the Paraffin level drops)
Made in England
UK Shipping This Item weighs 1.5 Kg without Packaging
Make sure lamp is turned off.
Unscrew pump and ensure there is sufficient paraffin in the tank, approx. half full, replace pump leave loose
Should you be re-lighting the lamp and know there is sufficient paraffin in the tank, always loosen pump to release any pressure present
Ensure mantle is in good order, (see 'fitting new mantle' if absent or damaged)
Soak preheater torch in methylated spirit.
Clip preheater torch around vapouriser stem, light and slide up under glass.
LEAVE THE LAMP ALONE!!, don't fiddle!, when the methylated spirit begins to burn down tighten the pump, this allows the heat to create pressure in the tank
Just before the methylated spirit goes out, turn on the lantern and the mantle should light with a gentle 'Pop' and give a slightly yellow light. give ten to twelve full strokes on the pump.
Allow to burn for 30 seconds or so then give several strokes on the pump, (up to forty), until the mantle is burning bright white and the lantern gives a steady hiss. Over-pumping will cause yellow flame outside the mantle and can damage the tank.
To extinguish the lamp simply turn the control knob off. and release the pressure by unscrewing the pump.
Older models have a small 'nipple' on the tank, if working, (and they seldom did), a rod will rise flush with the top of the nipple when pressure is correct. If the light begins to fade or the mantle strongly 'pulses' light give additional strokes of the pump to restore brightness.